Tempered Glass Screen Fitting

The Following is a generic screen fitting procedure that can be applied to the majority of screen protectors sold on this site.

​The current manual does not include using the guide stickers, but we highly recommend using them to ensure a perfect alignment with your screen, a video below is a good example of how to use them, please note this is not supplied by us.

at the bottom of this page the more advanced UV.​

Glass Screen Protector Fitment instructions.

​

  1. Clean screen using the wet wipes (Number 1)

  2. Dry the screen using dry wipes (Number 2)

  3. Dab dust absorber to remove any left over marks 

  4. Carefully Align screen protector to Phone screen

  5. Stick guide stickers to the screen protector and the phone (Using Guide Stickers)

  6. Fold out then back on to double check alignment

  7. Fold out again and peel off protective film

  8. Stick onto screen checking alignment

  9. Run your finger down the centre to activate the adhesive

  10. Remove guide stickers

  11. Process complete

​

Note:- if this isn’t clear please watch the below video.

Tempered glass screen protector fitment

A Video showing Screen Protector alignment (With Guide Stickers)

Glass Screen Protector UV Fitment instructions.

​

  1. Clean Screen using the wet wipes (Number 1)

  2. Dry the screen using dry wipes (Number 2)

  3. Dab dust absorber to remove any left over marks 

  4. squeeze a small amount of adhesive in the centre of the screen (must be on a flat surface)

  5. Align and Stick screen protector onto watch checking alignment

  6. remove any excess adhesive with tissue

  7. Power UV lamp via USB cable

  8. shine UV onto watch up and down for around 30 seconds

  9. Process complete

​

Note:- if this isn’t clear please watch the below video.

A Video showing UV Screen Protector alignment (With Guide Stickers)